Cisco 200-150 Dumps 2021

NEW QUESTION 1
When connecting a switch port to a virtualization host requiring 802.1q VLAN tagging, which spanning-tree port type should be configured on the switch?

• A. normal
• B. edge
• C. edge trunk
• D. PortFast
• E. trunk

Answer: C

NEW QUESTION 2
What happens when there is no entry in the Layer 2 CAM table that corresponds to the destination MAC address of an incoming frame?

• A. The frame is flooded out of all forwarding ports in all VLANs.
• B. The frame is flooded out of all forwarding ports in its VLAN, except the port on which it is received.
• C. The switch drops the frame.
• D. The frame is flooded out of all forwarding ports in its VLAN, including the port on which it is received.

Answer: B

NEW QUESTION 3
When using HSRP or VRRP, what are the two states of the router interfaces that are ready to take over forwarding for the link, if necessary? (Choose two)

• A. idle
• B. backup
• C. master
• D. Standby
• E. floating

Answer: BD

NEW QUESTION 4
Drag and drop the CLI configuration command on the left to the correct order on the right to configure a Layer 3 interface. Not all options are used.

Answer:

Explanation:
Interface ethernet1/13 No switchport
Ip address 192.168.1.254/24 No shutdown

NEW QUESTION 5
Drag and drop each port description on the left to the port type on the right required to support it.

Answer:

Explanation:
Fiber Channel: Fiber channel port Storage port
All others will go to the Ethernet.

NEW QUESTION 6
Which statement is correct regarding the assignment of endpoints to asubzone?

• A. By default, all endpoints are registered to the Neighbor Subzone.
• B. By default, all endpoints are registered to the Default Subzone.
• C. Registration Restriction Rule must be configured that matches the endpoint's alias or IP subnet.
• D. Endpoints making a traversal call must be registered to the Traversal Subzone.

Answer: B

NEW QUESTION 7
What is the principle function of the data center core layer?

• A. high-speed packet switching
• B. access control
• C. firewalling and intrusion prevention
• D. QoS marking

Answer: A

NEW QUESTION 8
Which two layers of the OSI model relate to the transmission of bits over the wire and packet forwarding based on destination IP address? (Choose two.)

• A. 1
• B. 2
• C. 3
• D. 4
• E. 5

Answer: AC

Explanation: Bits - 1 layer Packets - 3 layer
http://en.wikipedia.org/wiki/OSI_model

NEW QUESTION 9
Which protocol is used for an immersive telepresence meeting?

• A. H.239
• B. Assent
• C. TIP
• D. H.323

Answer: C

NEW QUESTION 10
A network design team has mandated that IP-only routing protocols be used in the network. Which two routing protocols will they want to use? (Choose two.)

• A. BGP
• B. OSPF
• C. RP
• D. EIGRP
• E. IS-IS

Answer: BD

Explanation: https://en.wikipedia.org/wiki/IS-IS

NEW QUESTION 11
Which statement about SAN zooming is true?

• A. Describes can belong to more than one zone.
• B. zones must be the same size.
• C. zone membership can be configured only on a pWWN basis.
• D. Hard zoning can be disabled

Answer: A

NEW QUESTION 12
What is the minimum number of disks that are needed in RAID 1?

• A. 4 disks
• B. 2 disks
• C. 8 disks
• D. 16 disks

Answer: B

NEW QUESTION 13
Which two port types are needed to build out an FCoE pass-through switch in NPV mode while maintaining Fiber Channel packet visibility? (Choose two.)

• A. VN Port
• B. VE Port
• C. VF Port
• D. Edge Port
• E. N Port

Answer: AC

NEW QUESTION 14
Which Cisco WebEx Center has program end campaign management?

• A. Cisco WebEx Event Center
• B. Cisco WebEx Support Center
• C. Cisco WebEx Meeting Center
• D. Cisco WebEx TrainingCenter

Answer: A

NEW QUESTION 15
Which two options describe Junctions of the data center aggregation layer? (Choose two)

• A. services layer
• B. high-speed packet switching O repeater
• C. access control
• D. QoS marking

Answer: AC

NEW QUESTION 16
Which type of cable do you use with a Cisco QSEP 40-Gbps BiDi transceiver?

• A. MMF
• B. active twinax
• C. STP
• D. SMF

Answer: A