Super to ccna wireless 200 355 pdf

Question No: 16

The introduction of consumer phones and tablets into enterprise WLANs can have an impact on 802.11a/b/g/n deployments. The Apple iPhone 4 and iPad 2 are very common examples.

Which statement best describes the abilities of these devices?

A. The Apple iPhone 4 and the iPad 2 use 2.4 GHz and 5 GHz. The Apple iPhone 4 uses only one spatial stream and the iPad 2 uses two spatial streams.

B. The Apple iPhone 4 uses only 2.4 GHz and the iPad 2 only uses 5 GHz. The Apple iPhone 4 uses only one spatial stream and the iPad 2 uses two spatial streams.

C. The Apple iPhone 4 uses 2.4 GHz and the iPad 2 uses 2.4 GHz or 5 GHz. The Apple iPhone 4 only uses one spatial stream and the iPad 2 uses two spatial streams.

D. The Apple iPhone 4 uses 2.4 GHz and the iPad 2 uses 2.4 GHz or 5 GHz. The Apple iPhone 4 and the iPad 2 use only one spatial stream.

Question No: 17

Which Extensible Authentication Protocol types are supported by the Cisco Unified Wireless Network?

A. EAP-TLS, PEAP-MSCHAPv2, and PEAP-GTC only

B. LEAP and EAP-FAST only

C. EAP-TLS, PEAP-MSCHAPv2, PEAP-GTC, LEAP, and EAP-FAST only

D. any EAP supported by the RADIUS authentication server

Question No: 18

In setting up the wireless network, it is desired that the DHCP server that is configured in WLC1 provides IP addressing to the WLAN. When devices attempt to join the network, they fail to receive an IP address in the range provided by the DHCP server in WLC1, but they do receive an IP address from the DHCP server in SW1. What is causing this issue?

A. The external DHCP server in SW1 will always be the preferred DHCP server and WLC1 will always be the secondary DHCP server in the WLAN.

B. The DHCP server address for SW1 needs to be removed from the DHCP server configuration in WLC1.

C. The primary DHCP server address in WLC1 is incorrect.

D. The primary DHCP server configured in WLC1 is not enabled.

Question No: 19

Due to the terrain, a deployment requires a point-to-point wireless bridge to allow for network connectivity to a remote building. What 5GHz band would permitted to use the highest power in the U.S.?

A. U-NII-3

B. U-NII-2 Extended

C. U-NII-2

D. U-NII-1

Question No: 20

What two methods of authentication are available for Local EAP?

A. LDAP and RADIUS

B. Local and RADIUS

C. Local Only

D. LDAP and Local

Question No: 21

Refer to the exhibit. An engineer wants to setup a mobility anchor for the Guest WLAN, but does not see the Anchor IP address listed in the drop-down. What is the most likely cause of this problem?

A. The mobility anchor is currently unreachable.

B. The mobility anchor must also be included in the mobility group of the WLC.

C. Layer 3 Security must be configured for Web Policy Authentication.

D. The mobility anchor is attached to another WLAN.

E. Layer 3 Security must be configured for Web Policy Passthrough.

Question No: 22

What is the function of the Cisco AnyConnect DART tool?

A. creates a compressed bundle of client logs and information

B. visualizes a WLAN environment, showing the possible locations of problems

C. gathers statistics from neighboring clients for comparison to the baseline

D. helps to troubleshoot a WLAN connection by using easy-to-use wizards and statistic viewers

Question No: 23

Which Cisco AnyConnect module allows troubleshooting for core Cisco AnyConnect problems?

A. telemetry

B. web security

C. VPN

D. NAM

E. DART

F. posture

G. CSSC