All About Verified 201 Exam Dumps

NEW QUESTION 1
What is the purpose of floating self-IP addresses?

• A. to define an address that grants administrative access to either system at any time
• B. to define an address that allows either system to initiate communication at any time
• C. to define an address that allows network devices to route traffic via a single IP address
• D. to define an address that gives network devices greater flexibility in choosing a path to forward traffic

Answer: C

NEW QUESTION 2
Which event is always triggered when a client initially connects to a virtual server configured with an HTTP profile?

• A. HTTP_DATA
• B. CLIENT_DATA
• C. HTTP_REQUEST
• D. CLIENT_ACCEPTED

Answer: D

NEW QUESTION 3
A BIG-IP Administrator needs to find which modules have been licensed for use on the BIG-IP system. In which section of the Configuration Utility can the BIG-IP Administrator find this information?

• A. System > Services
• B. System > Resource Provisioning
• C. System > Platform
• D. System > Support

Answer: B

NEW QUESTION 4
A BIG-IP Administrator reviews the Plane CPU Usage performance chart and discovers a high percentage of Control Plane utilization.
Which type of traffic does this indicate a higher usage of?

• A. Administrative
• B. Tunnel
• C. Accelerated ,
• D. Application

Answer: A

NEW QUESTION 5
A BIG-IP has two load balancing virtual servers at 150.150.10.10:80 and 150.150.10.10:443. The port 80 virtual server has SNAT automap configured. There is also a SNAT configured at 150.150.10.11 set for a source address range of 200.200.1.0 / 255.255.255.0. All other settings are at their default states. If a client with the IP address 200.200.1.1 sends a request to https://150.150.10.10, what is the source IP address when the associated packet is sent to the pool member?

• A. 200.200.1.1
• B. 150.150.10.11
• C. Floating self IP address on VLAN where the packet leaves the system
• D. Floating self IP address on VLAN where the packet arrives on the system

Answer: B

NEW QUESTION 6
Refer to the exhibit


The network team creates a new VLAN on the switches. The BIG-IP Administrator needs to create a configuration on the BIG-IP device. The BIG-IP Administrator creates a new VLAN and Self IP, but the servers on the new VLAN are NOT reachable from the BIG-IP device.
Which action should the BIG-IP Administrators to resolve this issue?

• A. Set Port Lockdown of Set IP to Allow All
• B. Change Auto Last Hop to enabled
• C. Assign a physical interface to the new VLAN
• D. Create a Floating Set IP Address

Answer: C

NEW QUESTION 7
The BIG-IP Administrator disable all pool members in a pool Users are still able to reach the pool members.
What is allowing users to continue to reach the disabled poo! members?

• A. A slow to time on Pool
• B. A persistence profile on the Virtual Server
• C. A slow ramp time on virtual Server
• D. A persistence profile on the Pool

Answer: B

NEW QUESTION 8
Which statement accurately describes the difference between two loadbalancing modes specified as "member" and "node"?

• A. There is no difference; the two terms are referenced for backward compatibility purposes.
• B. When the loadbalancing choice references "node", priority group activation is unavailable.
• C. Loadbalancing options referencing "nodes" are available only when the pool members are defined for the "any" port.
• D. When the loadbalancing choice references "node", the addresses' parameters are used to make the loadbalancing choice rather than the member's parameters.

Answer: B

NEW QUESTION 9
An application is configured so that the same pool member must be used for an entire session, as well as for HTTP and FTP traffic.
A user reports that a session has terminated, and the user must restart the session. The BIG-IP Administrator determines that the active BIG-IP device failed over to the standby BIG-IP device. Which configuration settings should the BIG-IP Administrator verify to ensure proper behaviour when BIG-IP failover occurs?

• A. cookie persistence and session timeout
• B. Stateful failover and Network Failover detection
• C. Persistence mirroring and Match Across Services
• D. syn-cookie insertion threshold and connection low-water mark

Answer: C

NEW QUESTION 10
A standard virtual server is defined with a pool and a SNAT using automap. All other settings for the virtual server are at defaults. When client traffic is processed by the BIG-IP, what will occur to the IP addresses?

• A. Traffic initiated by the pool members will have the source address translated to a self-IP address but the destination address will not be changed.
• B. Traffic initiated to the virtual server will have the destination address translated to a pool member address and the source address translated to a self-IP address.
• C. Traffic initiated by selected clients, based on their IP address, will have the source address translated to a self-IP address but the destination will only be translated if the traffic is destined to the virtual server.
• D. Traffic initiated to the virtual server will have the destination address translated to a pool member address and the source address translated to a self-IP addres
• E. Traffic arriving destined to other destinations will havethe source translated to a self-IP address only.

Answer: B

NEW QUESTION 11
When network failover is enabled, which of the following is true?

• A. The failover cable status is ignore
• B. Failover is determined by the network status only.
• C. Either a network failure or loss of voltage across the failover cable will cause a failover.
• D. A network failure will not cause a failover as long as there is a voltage across the failover cable.
• E. The presence or absence of voltage over the fail over cable takes precedence over network failover.

Answer: C

NEW QUESTION 12
A development team needs to apply a software fix and troubleshoot one of its servers. The BIG-IP Administrator needs to immediately remove all connections from the BIG-IP system to the back end server. The BIG-IP Administrator checks the Virtual Server configuration and finds that a persistence profile is assigned to it. What should the 8IG-IP Administrator do to meet this requirement?

• A. Set the pool member to a Forced Offline state and manually delete easting connections through the command line.
• B. Set the pool member to a Forced Offline state.
• C. Set the pool member to a Disabled state.
• D. Set the pool member to a Disabled state and manually delete existing connections through the command line.

Answer: A

NEW QUESTION 13
A BIG-IP Administrator needs to view the CPU utilization of a particular Virtual Server. Which section of the Configuration Utility should the administrator use for this purpose?

• A. Statistics > Module Statistics > Local Traffic > Virtual Addresses
• B. Statistics > Module Statistics > Traffic Summary
• C. Statistics > Analytics > Process CPU Utilization
• D. Statistics > Module Statistics > Local Traffic > Virtual Servers

Answer: D

NEW QUESTION 14
One of the two members of a device group has been decommissioned. The BIG-IP Administrator tries to delete the device group, but is unsuccessful.
Prior to removing the device group, which action should be performed?

• A. Disable the device group
• B. Remove all members from the device group
• C. Remove the decommissioned device from the device group
• D. Make sure all members of the device group are in sync

Answer: B

NEW QUESTION 15
An ecommerce company is experiencing latency issues with online shops during Black Friday's peak season. The BIG-IP Administrator detects an overall high CPU load on the BIG-IP device and wants to move the top utilized Virtual Servers to a dedicated BIG-IP device.
Where should the BIG-IP Administrator determine the problematic Virtual Servers?

• A. System > Plattform
• B. Local Traffic > Virtual Servers > Virtual Server List
• C. Local Traffic > Network Map
• D. Statistics > Module Statistics > Local Traffic > Virtual Servers

Answer: D

NEW QUESTION 16
You need to terminate client SSL traffic at the BIG-IP and also to persist client traffic to the same pool member based on a BIG IP supplied cookie. Which four are profiles that would normally be included in the virtual server's definition? (Choose four.)

• A. TCP
• B. HTTP
• C. HTTPS
• D. ClientSSL
• E. ServerSSL
• F. CookieBased Persistence

Answer: ABDF

NEW QUESTION 17
......