The Secret Of F5-Networks 201 Free Demo

Your success in F5-Networks 201 is our sole target and we develop all our 201 braindumps in a way that facilitates the attainment of this target. Not only is our 201 study material the best you can find, it is also the most detailed and the most updated. 201 Practice Exams for F5-Networks 201 are written to the highest standards of technical accuracy.

Free demo questions for F5-Networks 201 Exam Dumps Below:

NEW QUESTION 1
To increase available bandwidth of an existing Trunk, the BIG-IP Administrator is adding additional interfaces.
Which command should the BIG-IP Administrator run from within bosh shell?

  • A. tmsh create /net trunk trunk_A interfaces add {1.3.1.4}
  • B. tmsh create/sys trunk trunk_A interfaces add {1.3.1.4}
  • C. tmsh modify/sys trunk trunk^A interfaces add {1.3.1.4}
  • D. tmsh modify /net trunk trunk_A interfaces add {1.3.1.4}

Answer: D

NEW QUESTION 2
Which two statements are true about NATs? (Choose two.)

  • A. NATs support UDP, TCP, and ICMP traffic.
  • B. NATs can be configured with mirroring enabled or disabled.
  • C. NATs provide a one-to-one mapping between IP addresses.
  • D. NATs provide a many-to-one mapping between IP addresses.

Answer: AC

NEW QUESTION 3
Refer to the exhibit.
201 dumps exhibit
Which two pool members are eligible to receive new connections? (Choose two)

  • A. 10.21.0.102.80
  • B. 10.21.0.104.80
  • C. 10.21.0.105.80
  • D. 10.21.0.101.80
  • E. 10.21.0.103.80

Answer: BD

NEW QUESTION 4
Which statement is true concerning a functional iRule?

  • A. iRules use a proprietary syntax language.
  • B. iRules must contain at least one event declaration.
  • C. iRules must contain at least one conditional statement.
  • D. iRules must contain at least one pool assignment statement.

Answer: B

NEW QUESTION 5
A BIG-IP Administrator is unable to connect to the management interface via HTTPS. What is a possible reason for this issue?

  • A. The port lockdown setting is configured to Allow None.
  • B. An incorrect management route is specified.
  • C. The IP address of the device used to access the management interface is NOT included in the "P Allow" list in the Configuration Utility.
  • D. The IP address of the device used to access the management interface is NOT included in the "httpd Allow" list in the CLI.

Answer: D

NEW QUESTION 6
A site needs a virtual server that will use an iRule to parse HTTPS traffic based on HTTP header values. Which two profile types must be associated with such a virtual server? (Choose two.)

  • A. TCP
  • B. HTTP
  • C. HTTPS
  • D. ServerSSL

Answer: AB

NEW QUESTION 7
Assume a BIG-IP has no NATs or SNATs configured. Which two scenarios are possible when client traffic arrives on a BIG-IP that is NOT destined to a self-IP? (Choose two.)

  • A. If the destination of the traffic does not match a virtual server, the traffic will be discarded.
  • B. If the destination of the traffic does not match a virtual server, the traffic will be forwarded based on routing tables.
  • C. If the destination of the traffic matches a virtual server, the traffic will be processed per the virtual server definition.
  • D. If the destination of the traffic matches a virtual server, the traffic will be forwarded, but it cannot be loadbalanced since no SNAT has been configured.

Answer: AC

NEW QUESTION 8
A BIG-IP device has only LTM and ASM modules provisioned. Both have nominal provisioning level. The BI6-IP Administrator wants to dedicate more resources to the LTM module. The ASM module must remain enabled. Which tmsh command should the BIG-IP Administrator execute to obtain the desired result?

  • A. modify/sys provision asm level minimum
  • B. modify /sys provision Itm level dedicated
  • C. modify /sys provision asm level none
  • D. modify /sys provision Itm level minimum

Answer: A

NEW QUESTION 9
Which three iRule events are likely to be seen in iRules designed to select a pool for load balancing? (Choose three.)

  • A. CLIENT_DATA
  • B. SERVER_DATA
  • C. HTTP_REQUEST
  • D. HTTP_RESPONSE
  • E. CLIENT_ACCEPTED
  • F. SERVER_SELECTED
  • G. SERVER_CONNECTED

Answer: ACE

NEW QUESTION 10
Which statement is true concerning SNATs using automap?

  • A. Only specified self-IP addresses are used as automap addresses.
  • B. SNATs using automap will translate all client addresses to an automap address.
  • C. A SNAT using automap will preferentially use a floating self-IP over a nonfloating self-IP.
  • D. A SNAT using automap can be used to translate the source address of all outgoing traffic to the same address regardless of which VLAN the traffic is sent through.

Answer: C

NEW QUESTION 11
When initially configuring the BIG-IP system using the config utility, which two parameters can be set? (Choose two.)

  • A. the netmask of the SCCP
  • B. the IP address of the SCCP
  • C. the port lockdown settings for the SCCP
  • D. the netmask of the host via the management port
  • E. the IP address of the host via the management port
  • F. the port lockdown settings for the host via the management port

Answer: DE

NEW QUESTION 12
Refer to the exhibit.
201 dumps exhibit
A BIG-IP Administrator needs to configure health monitors for a newly configured server pool named Pool_B.
Which health monitor settings will ensure that all pool members will be accurately marked as available or unavailable?

  • A. HTTPS, HTTP, FTP, and ICMP, with the Availability Requirement of all health monitors
  • B. HTTPS, HTTP, FTP, and SSH, with the Availability Requirement of at least one monitor
  • C. HTTPS and HTTP with the Availability Requirement of at least one health monitor
  • D. HTTPS, HTTP, FTP, and SSH with the Availability Requirement of all health monitors

Answer: B

Explanation:
From the port, the four members are HTTP, FTP, HTTPS, and SSH applications. If you want to monitor at the same time, you must configure at least one.

NEW QUESTION 13
Assume a virtual server has a ServerSSL profile. What SSL certificates are required on the BIG-IP?

  • A. No SSL certificates are required on the BIG-IP.
  • B. The BIG-IP's SSL certificates must only exist.
  • C. The BIG-IP's SSL certificates must be issued from a certificate authority.
  • D. The BIG-IP's SSL certificates must be created within the company hosting the BIG-IPs.

Answer: A

NEW QUESTION 14
As a part of the Setup Utility, the administrator sets the host name for the BIG IP. What would be the result if the two systems in a redundant pair were set to the same host name?

  • A. Host names do not matter in redundant pair communication.
  • B. In a redundant pair, the two systems will always have the same host nam
  • C. The parameter is synchronized between the systems.
  • D. The first time the systems are synchronized the receiving system will be assigned the same self-IP addresses as the source system.
  • E. When the administrator attempts to access the configuration utility using the host name, they will always connect to the active system.

Answer: C

NEW QUESTION 15
A 8IG-IP device is replaced with an RMA device. The BIG-IP Administrator renews the license and tries to restore the configuration from a previously generated UCS archive on the RMA device. The device configuration is NOT fully loading. What is causing the configuration load to fail?

  • A. The Device Group is NOT configured for Full Sync.
  • B. The US does NOT contain the full config
  • C. The clock is NOT set correctly
  • D. The Master Key is NOT restored

Answer: D

NEW QUESTION 16
On the VCMP system, a BIG-IP host administrator imports a new ISO image into the host's /shared/images folder. The new ISO images that reside on the vCMP host are available for installation on the guest. How should the BIG-IP Administrator install one image from within the guest?

  • A. Install the new software on the host and wait for it to automatically be installed on all guests.
  • B. Run the following command on guesttmsh install sys software block-device-image image_name volume < volume_name>
  • C. Run the following command on guesttmsh install sys software image image_name volume < volume_name>
  • D. Run the following command on hosttmsh install sys software block-device-image image_name volume < volume_name>

Answer: D

NEW QUESTION 17
......

100% Valid and Newest Version 201 Questions & Answers shared by Certleader, Get Full Dumps HERE: https://www.certleader.com/201-dumps.html (New 254 Q&As)