2v0 620 dump pdf (31 to 40)


The article at Testaimer.com going over http://www.testaimer.com/2V0-620-test is very comprehensive.

Q31. Refer to the Exhibit. -- Exhibit --

An administrator has been given requirements to configure vMotion for a new virtual machine. The configuration should: 

Provide Network Redundancy 

Use VLAN 550 

Be secured against anyone trying to spoof communication 

The vSwitch1 configuration is shown in the Exhibit. 

Which three changes should be made to meet the stated requirements? (Choose three.) 

A. The VLAN ID must be set appropriately. 

B. The default values for MAC Address Changes and Forged Transmits must be altered. 

C. The teaming and failover adapters must be set appropriately. 

D. The Traffic Shaping configuration must be altered. 

E. The Load Balancing Policy must be set appropriately. 

Answer: A,B,C 


Q32. What is true regarding datastores on ESXi 6.x? 

A. NFS 4.1 datastore does not support Fault Tolerance (FT) 

B. VMFS3 and VMFS5 datastores can be newly created 

C. NFS datastore can be concurrently mounted using NFS 4.1 on one host and NFS on another 

D. NFS 3.0 datastore does not support Fault Tolerance (FT) 

Answer:


Q33. An administrator is creating a new Virtual SAN cluster on a Layer 2 network. There is an existing Virtual SAN cluster on the same Layer 2 network. 

Which two actions would allow the new Virtual SAN cluster to coexist with the older cluster? (Choose two.) 

A. Change the default Multicast Address on the new Virtual SAN cluster. 

B. Change the default Unicast Address on the new Virtual SAN Cluster. 

C. Create a separate VLAN for each cluster. 

D. Create an ARP Alias for the Virtual SAN VMkernel Network Adapter. 

Answer: A,C 


Q34. An administrator needs to verify that vMotion operations can be performed in a vSphere data center. 

What round trip time (RTT) latency is the maximum value that will allow vMotion operations to succeed? 

A. 50ms RTT 

B. 100ms RTT 

C. 150ms RTT 

D. 200ms RTT 

Answer:


Q35. A Fault Tolerance (FT) virtual machine with four vCPUs is experiencing high latency when performing ICMP and Application tests. 

What are three potential causes that may be attributing to this latency? (Choose three.) 

A. The FT network has insufficient bandwidth and is running on a 1GB Link. 

B. The FT network is on a particularly high latency link. 

C. The FT network has been configured with Network I/O Control. 

D. The FT virtual machine is running an e1000 network adapter. 

E. The FT virtual machine is running on poor performing network-based storage. 

Answer: A,B,C 


Q36. Which two statements are true regarding VMware vSphere Flash Read Cache (vFRC)? (Choose two.) 

A. Cache fills and cache evictions happen in the granularity of a cache block size. 

B. vFRC caches data from both read and write I/Os, but write I/Os are always serviced by the underlying storage. 

C. vFRC caches data from both read and write I/Os, but write I/Os are always serviced by the underlying cache data. 

D. Cache fills and cache evictions happen in the granularity of the disk block size. 

Answer: A,B 


Q37. An administrator has configured an alarm to be notified when a virtual machine meets either of these conditions: 

. High virtual CPU 

. High active memory consumption. 

The alarm is only triggering when both of the conditions are met. 

What can be done to correct the alarm behavior? 

A. Edit the alarm and select Trigger if ANY of the following conditions are satisfied. 

B. Edit the alarm and select Trigger if ALL of the following conditions are satisfied. 

C. Create two separate alarms, one for CPU and one for memory and link them together with ESXCLI. 

D. Delete the existing alarm and create a new event based alarm. 

Answer:


Q38. Which vSphere 6 Standard Edition feature will allow an organization to ensure that critical multi-threaded applications have the maximum possible uptime? 

A. Fault Tolerance 

B. High Availability 

C. Distributed Resource Scheduler 

D. App HA 

Answer:


Q39. An administrator configures vSphere Replication for a virtual machine and enables multiple point in time (PIT) instances under the recovery settings in the Configure Replication wizard. 

Which two statements are correct for vSphere Replication with multiple point in time instances enabled? (Choose two.) 

A. vSphere Replication retains a number of snapshot instances of the virtual machine on the target site based on the retention policy that you specify. 

B. vSphere Replication uses the virtual machine's snapshot instances to define the target site Point in Time instance based on the retention policy that you specify. 

C. vSphere Replication does not support virtual machines with snapshots. 

D. vSphere Replication supports virtual machines with snapshots. 

Answer: A,C 


Q40. vMotion can be performed between which three physical boundaries? (Choose three.) 

A. Between two vCenter Server Systems 

B. Between two vSphere Distributed Virtual Switches 

C. Between two vCenter Server Datacenter objects 

D. Between two VMware NSX Layer 4 segments 

E. Between two NFS datastores 

Answer: A,B,C