Finding Improved 300-070 paper

Most of the customers keep trust on us because of the warranty that more than 95% passing guarantee. Otherwise, full refund or another goods. We in addition provide using consolation for the unsuccessful customers. Without any delay if they will fail the Cisco Cisco exam. Simply contact the Customer Assistance to claim the actual refund or trade the goods. Further far more, you have to attach the actual failed transcript.


The article at Testaimer.com going over http://www.testaimer.com/300-070-test is very comprehensive.

2021 Mar 300-070 vce

Q11. After you configure a dial plan to call a particular prefix in the PSTN, you notice that some outbound calls are taking longer than usual (15 seconds) before you hear a connecting tone. What is the likely cause of this issue? 

A. The outbound gateway must be configured with the new prefix. 

B. The endpoint is choosing the best codec to use. 

C. The new prefix is overlapping other route patterns. 

D. With some prefixes, this is normal behavior of the PSTN. 

Answer:

Explanation: Reference: 

Page 107 

CIPTV110SG_Vol1 


Q12. Which command is used to enter the DSP farm profile configuration mode? 

A. dspfarm-profile 100 transcode 

B. dspfarmprofile 100 transcode 

C. dspfarm profile 100 transcode 

D. dspfarm 100 profile transcode 

Answer:


Q13. Which two statements about Cisco VCS Addressing Zones are true? (Choose two.) 

A. They can be local to the Cisco VCS or can be remote. 

B. A zone is a collection of endpoints that share the same dialing behavior and bandwidth settings. 

C. They consist of traversal and nontraversal zones. 

D. They can only be local. 

E. They consist of subzones such as DNS zones. 

Answer: A,B 


Q14. A customer recently installed a Cisco TelePresence MCU 5320. The customer wants a 

virtual meetingroom that restricts participants from communicating before the customer joins the call. 

Which featurein the MCU enables this functionality? 

A. Floor and chair control. 

B. Numeric ID. 

C. PIN codes. 

D. Owner. 

Answer:

Explanation: Reference: 

http://www.cisco.com/c/dam/en/us/td/docs/telepresence/infrastructure/mcu/admin_guide/cis co_telepresence_mcu_5300_series_administration_guide_4-3_2-17.pdf 


Q15. Which parameter is required on MCU for ad hoc conferencing? 

A. Media Port reservation 

B. incoming calls to unknown conferences or auto-attendants 

C. DSP reservation for video 

D. MCU type 

E. MCU Conference Bridge SIP Port 

Answer:


Latest 300-070 pdf exam:

Q16. Which three configuration options are currently unsupported when configuring the Cisco UnifiedBorder Element for videoconferencing? (Choose three) 

A. RSVP synchronization of H.323 calls. 

B. Multiple logical channels per call leg. 

C. H.323-to-SIP video traffic. 

D. FECC support. 

E. Video endpoints with different H.245 versions. 

F. Dual video/picture-in-picture. 

G. DSCP marking for video streams. 

Answer: C,E,F 

Explanation: Reference: 

http://www.cisco.com/c/en/us/td/docs/ios/voice/cube/configuration/guide/15_2/vb_gw_15_2_book/vb-gwvideo. 


Q17. Which protocol is recommended to be used between Cisco Unified Communications Manager and thevoice gateway to simplify the dial plan? 

A. SIP. 

B. SCCP. 

C. H323. 

D. RSVP. 

E. MGCP. 

Answer:


Q18. Which statement about translation patterns and transformation patterns is true? 

A. Both transformation patterns and translations patterns support only numeric values. 

B. Both transformation patterns and translations patterns support numeric and alphanumeric values. 

C. Transformation patterns support numeric and alphanumeric values, whereas translations patterns supportonly numeric values. 

D. Translation patterns support numeric and alphanumeric values, whereas transformation patterns supportonly numeric values. 

Answer:

Explanation: Reference: 

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/8_6_1/ccmcfg/bccm-861-cm/b03txpat.html 

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/8_6_1/ccmcfg/bccm-861-cm/b03cldpt.html 


Q19. Which mechanism is often configured on the edges of a network to control the maximum rate of traffic that is sent or received on an interface and to classify the traffic into priority levels or class of service? 

A. routing 

B. shaping 

C. policing 

D. access control 

E. traffic regulation 

Answer:


Q20. Refer to the exhibit. 

To reach an external number, a user first dials a 9. Which route pattern will be matched if a user dials the toll-free number 18005550123? 

A. 911 

B. 9.[2-9]XXXXXX 

C. 9.1[2-9]XX[2-9]XXXXXX 

D. 9.1800XXXXXXX 

E. 9.1866XXXXXXX 

F. 9.1877XXXXXXX 

G. 9.1888XXXXXXX 

H. 9.1900XXXXXXX 

I. 9011! 

Answer: