Foolproof 300 070 ciptv1 pdf tips

Proper study guides for Rebirth Cisco Implementing Cisco IP Telephony & Video, Part 1 v1.0 certified begins with Cisco 300 070 ciptv1 preparation products which designed to deliver the High value 300 070 ciptv1 pdf questions by making you pass the cisco 300 070 test at your first time. Try the free 300 070 ciptv1 pdf demo right now.

Q21. Which of these determines the Cisco Unified Communications Manager server to which an IP phone registers? 

A. The Cisco Unified Communications Manager group is configured with a Device Pool that designates the primary, secondary, and tertiary servers in the group. 

B. Each IP phone is configured with a Device Pool containing the Cisco Unified Communications Manager group that determines which server the IP phone will use as its primary, secondary, and tertiary server. 

C. Each IP phone is configured with its primary, secondary, and tertiary server. 

D. The Cisco Unified Communications Manager group is configured in the publisher to designate the IP phone groups that will register with the primary, secondary, and tertiary servers in the group. 

Answer:


Q22. Refer to Exhibit: 

If the user at extension 1001 dials the user at extension 2011, which dial peer is used to 

route the call? 

A. 3 

B. 2 

C. 4 

D. 1 

Answer:


Q23. Refer to the exhibit. 

To reach an external number, a user first dials a 9. Which route pattern will be matched if a user dials the toll-free number 18005550123? 

A. 911 

B. 9.[2-9]XXXXXX 

C. 9.1[2-9]XX[2-9]XXXXXX 

D. 9.1800XXXXXXX 

E. 9.1866XXXXXXX 

F. 9.1877XXXXXXX 

G. 9.1888XXXXXXX 

H. 9.1900XXXXXXX 

I. 9011! 

Answer:


Q24. Which three steps must you take on Cisco Unified Communications Manager to configure 

Cisco TelePresence Conductor for ad hoc and rendezvous conferences? (Choose three.) 

A. Verify the location configuration. 

B. Verify the certificate trusts. 

C. Configure one ICT trunk to TelePresence Conductor. 

D. Configure one SIP trunk to TelePresence Conductor. 

E. Configure two ICT trunks to TelePresence Conductor. 

F. Configure two SIP trunks to TelePresence Conductor. 

Answer: A,B,F 


Q25. In a centralized call-processing solution, there are five sites connected through an IP WAN. To optimizethe utilization of the IP WAN, CAC needs to be implemented. 

How should CAC be implemented? 

A. Use a gatekeeper to control allocated bandwidth properly. 

B. Use locations CAC with a single location. 

C. Use a gatekeeper and Cisco Unified Border Element to provide CAC to sites that use a combination of SIPand MGCP gateways. 

D. Use a gatekeeper to only control those locations that use H.323 gateways and a Cisco Unified BorderElement to control those sites that use MGCP or SIP gateways. 

E. Use locations CAC with five locations in addition to Hub none. 

Answer:


Q26. Which four software based media resources require that the Cisco IP voice media streamApplicationbe activated? 

A. MOH. 

B. SIP. 

C. H.323 Gateways. 

D. Annunciator. 

E. Gatekeeper. 

F. MTP. 

G. Audio conferencing. 

Answer: A,D,F,G 


Q27. Which protocol can Cisco Unified Communications Manager not use to monitor the status of thegateway? 

A. H.323 

B. SIP 

C. MGCP 

D. SCCP 

Answer:


Q28. Which statement regarding Cisco IP voice media streaming application is correct? 

A. It should be activated on the gateway in cluster that supports the TFTP service. 

B. It should be activated on the gatekeeper in cluster that supports the TFTP service. 

C. It should be activated on the node in cluster that does not support the TFTP service. 

D. It should be activated on the node in cluster that supports the TFTP service. 

Answer:


Q29. Which configuration output indicates a properly configured T1 digital voice interface? 

A. controller T1 0/0/0 

framing esf 

linecode b8zs 

pri-group timeslots 1-24 

B. isdn switch-type primary-ni 

controller T1 0/0/0 

framing esf 

linecode b8zs 

C. isdn switch-type primary-ni 

controller T1 0/0/0 

framing esf 

linecode b8zs 

pri-group timeslots 1-24 

isdn switch-type primary-ni 

D. isdn switch-type primary-ni 

controller T1 0/0/0 

framing esf 

linecode b8zs 

dial-peer voice 1 pots 

destination-pattern 54…. 

direction-inward.dial 

port 0/0/0:23 

Answer:


Q30. Which distribution algorithm is used for a route group? 

A. Circular, top down. 

B. Longest idle, broadcast. 

C. Circular, top down, longest idle, broadcast. 

D. Top down, broadcast, circular. 

Answer:

Explanation: 

Reference: 

Page 199 

Cisco Unified Communications Manager Administration Guide, Release 10.0(1)