how to use cisco 300 075

Want to know Pass4sure 300 075 ciptv2 Exam practice test features? Want to lear more about Cisco Implementing Cisco IP Telephony and Video, Part 2 (CIPTV2) certification experience? Study Accurate Cisco 300 075 vce answers to Regenerate 300 075 ciptv2 questions at Pass4sure. Gat a success with an absolute guarantee to pass Cisco 300 075 pdf (Implementing Cisco IP Telephony and Video, Part 2 (CIPTV2)) test on your first attempt.


The article at Testaimer.com going over http://www.testaimer.com/300-075-test is very comprehensive.

Q81. Which configuration command disables the secondary dial tone on the branch office ISR for users calling from the PSTN into the branch office during a WAN failure? 

A. direct-inward-dial 

B. voice translation-rule 

C. incoming called-number 

D. application 

Answer:


Q82. Which statement about Service Advertisement Framework is true? 

A. SAF requires that the EIGRP be configured on all routers, including non-SAF routers. 

B. SAF requires that the EIGRP be configured only on SAF routers. Non-SAF routers act as an IP cloud. 

C. SAF has no dependency on the underlying routing protocol, as long as it is a dynamic routing protocol. Static routes are not supported. 

D. SAF operates on any dynamic or static IP routing configuration. SAF is totally independent of the underlying routing protocol. 

Answer:

Explanation: 

Because Cisco SAF is independent of IP routing and uses underlying Cisco routing technology to distribute service advertisements in a reliable and efficient manner, Cisco SAF will run in networks over any routing protocol they may have in place such as Enhanced Interior Gateway Routing Protocol (EIGRP), Open Shortest Path First (OSPF), Exterior Border Gateway Protocol (EBGP) over an MPLS service, or static routing (Figure 2). 

http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6554/ps6599/ps10822/whitepaper_c11-636604.html 


Q83. DRAG DROP 

Answer: 


Q84. Refer to the exhibit. 

When a call between two HQ users is being conferenced with a remote user at BR, which configuration is needed? 

A. The BR_MRG must contain the transcoder device. The BR_MRGL must be assigned to the BR phones. 

B. The HQ_MRG must contain the transcoder device. The HQ_MRGL must be assigned to the HQ phones. 

C. A transcoder should be configured at the remote site and assigned to all remote phones through the BR_MRGL. 

D. The HQ_MRG must contain the transcoder device. The HQ_MRGL must be assigned to the software conference bridge. 

E. Enable the software conference bridge to support the G.711 and G.729 codecs in Cisco Unified Communications Manager Service Parameters. 

Answer:


Q85. When multiple Cisco Extension Mobility profiles exist, which actions take place when a user tries to log in to Cisco Extension Mobility? 

A. The login will fail because only a single Cisco Extension Mobility profile is allowed. 

B. The user must select the desired profile. 

C. The user must login to both profiles in the order they are presented. 

D. The user may login to both profiles in any order. 

E. Login will only be allowed to multiple profiles if the service parameter Allow Multiple Logins is enabled. 

Answer:

Explanation: 

Incorrect Answer: A, C, D, E Users access Cisco Extension Mobility by pressing the Services or Applications button on a Cisco Unified IP Phone and then entering login information in the form of a Cisco Unified Communications Manager UserID and a Personal Identification Number (PIN). If a user has more than one user device profile, a prompt displays on the phone and asks the user to choose a device profile for use with Cisco Extension Mobility. Link: 

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmfeat/fsem.html 


Q86. Which option is a benefit of implementing CFUR? 

A. CFUR is designed to initiate TEHO to reduce toll charges. 

B. CFUR can prevent phones from unregistering. 

C. CFUR can reroute calls placed to a temporarily unregistered destination phone. 

D. CFUR eliminates the need for COR on an ISR. 

Answer:


Q87. Scenario 

There are two call control systems in this item. The Cisco UCM is controlling the DX650, the Cisco Jabber for Windows Client, and the 9971 Video IP Phone. The Cisco VCS and TMS control the Cisco TelePresence MCU, and the Cisco Jabber TelePresence for Windows. 

Use the exhibits to answer the following questions. 

DP 

Locations 

CSS 

SRST 

SRST-BR2 Config 

BR2 Config 

SRSTPSTNCall 

After configuring the CFUR for the directory number that is applied to BR2 phone (+442288224001), the calls fail from the PSTN. Which two of the following configurations if applied to the router, would remedy this situation? (Choose two.) 

A. dial-peer voice 1 potsincoming called-number 228822…direct-inward-dialport 0/0/0:15 

B. dial-peer voice 1 potsincoming called-number 228822…direct-inward-dialport 0/0/0:13 

C. voice translation-rule 1rule 1 /228821 …$/ /+44&/exit!voice translation-profile pstn-intranslate called 1!voice-port 0/0/0:15translation-profile incoming pstn-in 

D. voice translation-rule 1rule 1 /228822…$/ /+44&/exit!voice translation-profile pstn-intranslate called 1!voice-port 0/0/0:15translation-profile incoming pstn-in 

E. The router does not need to be configured 

Answer: A,D 


Q88. Which minimum configuration is needed for the SAF Internal Client to register with this SAF Forwarder? 

A. router eigrp SAF!service-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit-service-family!voice service safprofile trunk-route 1session protocol sip interface Loopbackl transport tcp port 5060i 

B. router eigrp SAF!service-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit-service-family!voice service safprofile trunk-route 1session protocol sip interface Loopbackl transport tcp port 5060!profile dn-block 1 alias-prefix 1972555pattern 1 type extension 4xxx!profile callcontrol 1dn-servicetrunk-route 1dn-block 1dn-block 2i 

C. router eigrp SAF!service-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit-service-family!voice service safprofile trunk-route 1session protocol sip interface Loopbackl transport tcp port 5060!profile dn-block 1 alias-prefix 1972555pattern 1 type extension 4xxx!profile callcontrol 1dn-servicetrunk-route 1dn-block 1dn-block 2!channel 1 vrouter SAF asystem 1subscribe callcontrol wildcardedpublish callcontrol 1i 

D. router eigrp SAF!service-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit-service-family!voice service saf!channel 1 vrouter SAF asystem 1 

E. router eigrp SAF!service-family ipv4 autonomous-system 1!topology base exit-sf-topologyexit-service-family i 

Answer:


Q89. When an H.323 trunk is added for Call Control Discovery, which statement is true? 

A. The H.323 trunk is added by selecting Inter-Cluster Trunk (Non-Gatekeeper Controlled) and Device Protocol Inter-Cluster Trunk. The Enable SAF check box should be selected in the trunk configuration. 

B. The H.323 trunk is added by selecting Inter-Cluster Trunk (Non-Gatekeeper Controlled) and Device Protocol Inter-Cluster Trunk. The Trunk Service Type should be Call Control Discovery. 

C. The H.323 trunk is added by selecting Call Control Discovery Trunk and then selecting 

H.323 as the protocol to be used. 

D. The H.323 trunk is added by selecting H.323 Trunk, and selecting Inter-Cluster Trunk as the Device Protocol. The destination IP address field is configured as ‘SAF’ to indicate that this trunk is used for SAF. 

Answer:

Explanation: 

Reference. Implementing Cisco Unified Communications Manager Part 2 (CIPT2), Chapter3: Implementing Multisite Connections, pg 70-71, Fig 3-14 and Fig 3-15 


Q90. Refer to the exhibit. 

To permit three G.729 calls, what should the bandwidth value be for the ip rsvp bandwidth command? 

A. 32 

B. 48 

C. 64 

D. 88 

E. 128 

Answer: