Super to cisco 300 075
Master the 300 075 dump Implementing Cisco IP Telephony and Video, Part 2 (CIPTV2) content and be ready for exam day success quickly with this Testking 300 075 pdf free practice questions. We guarantee it!We make it a reality and give you real 300 075 vce questions in our Cisco cisco 300 075 braindumps.Latest 100% VALID Cisco 300 075 ciptv2 Exam Questions Dumps at below page. You can use our Cisco 300 075 ciptv2 braindumps and pass your exam.
The article at Testaimer.com going over http://www.testaimer.com/300-075-test is very comprehensive.
Q61. A Cisco 3825 needs to be added in Cisco Unified Communications Manager as an H.323 gateway. What should the gateway type be?
A. H.323 gateway
B. Cisco 3825
C. Cisco 3800 series router. The specific model will be selected after the Cisco 3800 is selected.
D. The gateway can be added either as an H.323 gateway or Cisco 3800 series router.
E. The gateway can be added either as an H.323 gateway or Cisco 3825 series router.
Q62. Which method can be used to address variable-length dial plans?
A. Overlap sending and receiving.
B. Add a prefix for all calls that are longer than 10-digits long
C. Use nested translation patterns to eliminate inter-digit timeout
D. Use the @macro on the route pattern
E. Use MGCP gateways, which support variable-length dial plans
Incorrect Answer: B, C, D, E If the dial plan contains overlapping patterns, Cisco Unified Communications Manager does not route the call until the interdigit timer expires (even if it is possible to dial a sequence of digits to choose a current match). Check this check box to interrupt interdigit timing when Cisco Unified Communications Manager must route a call immediately. By default, the Urgent Priority check box displays as checked. Unless your dial plan contains overlapping patterns or variable length patterns that contain!, Cisco recommends that you do not uncheck the check box. Link:
Q63. Which component of Cisco Unified Communications Manager is responsible for sending keepalive messages to the Service Advertisement Framework forwarder?
A. Call Control Discovery requesting service
B. Hosted DNs service
C. Service Advertisement Framework client control
D. Cisco Unified Communications Manager database
E. Service Advertisement Framework-enabled trunk
Q64. Which ability does the Survivable Remote Site Telephony feature provide?
A. a means to allow the local site to continue to send and receive calls in the event of a WAN failure
B. a means to route calls on-net through other sites during high utilization periods
C. a method that allows for backup calls in the event that your gateway fails
D. the ability to force a call out of a certain trunk when the Cisco Unified Communications Manager is being upgraded
Q65. To preserve analog calls in an MGCP switchback event, which three commands must be configured in the MGCP fallback router? (Choose three.)
C. voice service voip
F. no h225 timeout keepalive
Incorrect Answer: B, D, E these additional command for call preservation when using MGCP fallback: voice service voip h323 no h225 timeout keepalive Reference. CCNP Voice CIPT2 642-457 Quick Reference, 2nd Edition
Q66. Which statement is not true about GARP?
A. GARP attacks require access to the target LAN or VLAN.
B. GARP can be used for a man-in-the-middle attack.
C. GARP is normally used for HSRP.
D. GARP can be disabled at Cisco IP phones.
Incorrect Answer: A, B, D
GARP (Gratuitous ARP) announce the presence of IP Phone on the network.
Q67. If the device pool in the phone record does not match the device pools in the matching subnet, what will the system consider the phone to be?
D. new device
Q68. Enabling authentication and encryption for CTI, JTAPI, and TAPI applications requires which two tasks? (Choose two.)
A. Enter the encryption key into the application.
B. Set up an IPsec association between the application and Cisco Unified CallManager.
C. Configure related security parameters in the CTI, JTAPI, and TAPI application.
D. Add the application user or end users to the Standard CTI Secure Connection user group, Standard CTI Allow Reception of SRTP Key Material user group, and Standard CTI Enabled user group.
Incorrect Answer: A, B You must also add the application users or the end users to the Standard CTI Secure Connection user group in Cisco Unified Communications Manager Administration to enable TLS for the application. After you add the user to this group and install the certificate, the application ensures that the user connects via the TLS port. Link:
Q69. Refer to the exhibit.
All HQ phones are configured to use HQ_MRGL and all BR phones are configured to use BR_MRGL. For the HQ phones always to use the hardware conference bridge as a first choice, which configuration should be implemented?
A. Ensure that both the hardware and software conference bridges are listed in the HQ_MRG. Ensure that the instance ID for the hardware conference bridge is 0.
B. Ensure that both the hardware and software conference bridges are listed in the HQ_MRG. The hardware conference bridge must be configured first.
C. Assign the hardware conference bridge to HQ_MRG. Configure a second HQ_MRG_2 and assign the software conference bridge to it. Add both the HQ_MRG and HQ_MRG_2 to the HQ_MRGL and list the HQ_MRG first.
D. Assign the hardware conference bridge to HQ_MRG. Configure a second HQ_MRG_2 and assign the software conference bridge to it. Configure an additional HQ_MRGL_2. Add the HQ_MRG to HQ_MRGL. Add HQ_MRG_2 to HQ_MRGL_2. The HQ_MRGL should be assigned to the HQ phones. The HQ_MRGL_2 should be assigned to the HQ device pool.
To ensure that the hardware bridge is utilized first with all its resources BEFORE the software bridge is used … you need to have two separate MRG’s and list the hardware MRG 1st in the MRGL …
Q70. Which device is used to connect to the H.323 gatekeeper?
A. H.323 gateway
B. SIP trunk
C. H.323 trunk
D. MGCP gateway