The Only Tip You Need: cisco 300 075

Master the cisco 300 075 Implementing Cisco IP Telephony and Video, Part 2 (CIPTV2) content and be ready for exam day success quickly with this Exambible 300 075 dump free practice test. We guarantee it!We make it a reality and give you real cisco 300 075 questions in our Cisco 300 075 pdf braindumps.Latest 100% VALID Cisco 300 075 dump Exam Questions Dumps at below page. You can use our Cisco 300 075 ciptv2 braindumps and pass your exam.

Q1. Which command is needed to utilize local dial peers on an MGCP-controlled ISR during an SRST failover? 

A. ccm-manager fallback-mgcp 

B. telephony-service 

C. dialplan-pattern 

D. isdn overlap-receiving 

E. voice-translation-rule 


Q2. Which ability does the Survivable Remote Site Telephony feature provide? 

A. a means to allow the local site to continue to send and receive calls in the event of a WAN failure 

B. a means to route calls on-net through other sites during high utilization periods 

C. a method that allows for backup calls in the event that your gateway fails 

D. the ability to force a call out of a certain trunk when the Cisco Unified Communications Manager is being upgraded 


Q3. Refer to the exhibit. 

When the user of a phone registered to the Cisco Unified Communications Manager places a call to 3001 when the SAF network is down, what happens? 

A. The call fails. 

B. The call is rerouted to the PSTN with the constructed PSTN number as +442288223001 

C. The call is rerouted to the PSTN with the constructed PSTN number as 442288223001 

D. The call is rerouted to the PSTN with the constructed PSTN number as 0002288223001 

E. The call is rerouted to the PSTN with the constructed PSTN number as +0002288223001 



Incorrect Answer: B, C, D When the SAF forwarder loses network connection with its call-control entity, the SAF forwarder withdraws those learned patterns that were published by the call control entity. In this case, CCD requesting service marks those learned patterns as unreachable via IP, and the calls get routed through the PSTN gateway. Link: discovery.html 

Q4. Refer to the exhibit. 

The HQ site uses area code 650. The BR1 site uses area code 408. The long distance national code for PSTN dialing is 1. To make a long distance national call, an HQ or BR1 user dials access code 9, followed by 1, and then the 10-digit number. Both sites use MGCP gateways. AAR must use globalized call routing using a single route pattern. Assume that all outgoing PSTN numbers are localized at the egress gateway as shown in the exhibit. Which statement is true? 

A. The AAR group system must be configured on the device configuration of the phones. 

B. The AAR group system must be configured on the line configuration of the phones. 

C. The single AAR group system cannot be used. A second AAR group must be configured in order to have source and destination AAR groups. 

D. The AAR group system must be configured under the AAR service parameters. 


Q5. In which two locations can you verify that a phone has a standby Cisco Unified Communications Manager? (Choose two.) 


B. phone menu 

C. Cisco Unified Serviceability 

D. phone webpage 

Answer: B,D 

Q6. Scenario 

There are two call control systems in this item. The Cisco UCM is controlling the Cisco Jabber for Windows Client, and the 7965 and 9971 Video IP Phone. The Cisco VCS is controlling the SX20, the Cisco TelePresence MCU, and the Cisco Jabber TelePresence for Windows. 

Use the exhibits to answer the following questions. 




Movi Failure 

Movi Settings 





What two issues could be causing the Cisco Jabber Video for TelePresence failure shown in the exhibit? (Choose two.) 

A. Incorrect username and password 

B. Wrong SIP domain configured. 

C. User is not associated with the device. 

D. IP or DNS name resolution issue. 

E. CSF Device is not registered. 

F. IP Phone DN not associated with the user. 

Answer: B,D 

Q7. Which statement about the host portion format in Cisco Unified Communications Manager URI dialing is false? 

A. The host portion cannot start or end with a hyphen. 

B. The host portion is not case sensitive. 

C. The host portion accepts characters a-z, A-Z, 0-9, hyphens, and periods. 

D. The host portion can have two periods in a row. 


Q8. Refer to the exhibit. 

HQ_MRGL is assigned to the HQ IP phones. BR_MRGL is assigned to the BR IP phones. The remote site BR IP phones support only the G.711 codec. Where should the transcoder reside? 

A. The transcoder should reside at the HQ site and assigned to HQ_MRG. 

B. The transcoder should reside at the BR site and assigned to BR_MRG. 

C. The transcoder should be assigned to its own MRG, which should then be assigned to the default device pool. 

D. A transcoder is not needed. The HQ phones will automatically change over to the G.711 codec. 


Q9. In a Centralized Call processing architecture, you have deployed Extension Mobility (EM) feature. After the deployment of EM, when one of the end-users tries to login to the IP phone, the Error 25 is displayed on the screen. What three things should you do to resolve this issue? (Choose three.) 

A. upgrade the firmware of the IP Phone to the latest version 

B. activate EM feature service under Cisco Unified Serviceability 

C. associate EM Device profile with the end-user 

D. subscribe the MAC address of the IP Phone to EM Service 

E. update EM Phone Service URL to point to the publisher 

F. subscribe device profile to EM phone service in case the enterprise subscription of EM Service is disabled 

Answer: B,C,D 

Q10. Refer to the exhibit: 

The exhibit shows a SAF Forwarder configuration attached to a Cisco Unified Communications Manager. 

Which minimum configuration for a Cisco Unified Communications Manager Express SAF Forwarder is needed to establish a SAF neighbor relationship with this SAF Forwarder? 

A. router eigrp SAFiservice-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit-service-familyvoice service safprofile trunkroute 1session protocol sip interface Loopback1 transport tcp port 5060! 

B. router eigrp SAF!service-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit- service-family!voice service safprofile trunk-route 1session protocol sip interface Loopback1 transport tcp port 5060!profile dn-block 1 alias-prefix 1972555pattern 1 type extension 4xxx!profile callcontrol 1dn-servicetrunk-route 1dn-block 1dn-block 2!channel 1 vrouter SAF asystem 1subscribe callcontrol wildcardedpublish callcontrol 1! 

C. router eigrp SAF!service-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit-service-family! 

D. None of above configurations contain sufficient information. 



Incorrect Answer: A, B, D only following configuration is enough router eigrp SAF service-family ipv4 autonomous-system 1 exit-service-family link: