Secrets to cisco 300 075
Your success in Cisco cisco 300 075 is our sole target and we develop all our 300 075 pdf braindumps in a way that facilitates the attainment of this target. Not only is our 300 075 vce study material the best you can find, it is also the most detailed and the most updated. 300 075 ciptv2 Practice Exams for Cisco CCNP Collaboration 300 075 pdf are written to the highest standards of technical accuracy.
Q31. Which three devices support the SAF Call Control Discovery protocol? (Choose three.)
A. Cisco Unified Border Element
B. Cisco Unity Connection
C. Cisco IOS Gatekeeper
D. Cisco Catalyst Switch
E. Cisco IOS Gateway
F. Cisco Unified Communications Manager
Q32. Which two actions ensure that the call load from Cisco TelePresence Video Communication Server to a Cisco Unified Communications Manager cluster is shared across Unified CM nodes? (Choose two.)
A. Create a neighbor zone in VCS with the Unified CM nodes listed as location peer addresses.
B. Create a single traversal client zone in VCS with the Unified CM nodes listed as location peer addresses.
C. Create one neighbor zone in VCS for each Unified CM node.
D. Create a VCS DNS zone and configure one DNS SRV record per Unified CM node.
E. In VCS set Unified Communications mode to Mobile and remote access and configure each Unified CM node.
Q33. With Cisco Extension Mobility, when a user logs in to a phone type which has no user device profile, what will happen to the phone?
A. The phone takes on the default clusterwide device profile.
B. The phone creates a new device profile automatically.
C. The phone immediately logs the user off.
D. The phone crashes and reboots.
Q34. Which two options are effective mechanisms to restrict the maximum number of voice calls on a WAN link? (Choose two.)
A. Configure a gatekeeper with an SIP trunk.
B. Configure a gatekeeper and a gatekeeper-controlled trunk in Cisco Unified Communications Manager with bandwidth control.
C. Configure Cisco Unified Communications Manager regions.
D. Configure Cisco Unified Communications Manager locations.
Q35. Refer to the exhibit.
You have configured transcoder resources in both an IOS router and a Cisco Unified Communications Manager. When you review the configurations in both devices the IP addresses and transcoder names are correct, but the transcoder is failing to register with the Cisco Unified Communications Manager. Which command needs to be edited to allow the transcoder to register properly?
A. The associate profile and dsp farm profile numbers need to match associate ccm 2 command.
B. The associate ccm 2 priority 1 command needs to be changed so the ccm value matches identifier 1 in the sccp ccm 10.1.1.1 command.
C. The sccp ccm group number needs to match the associate ccm 2 command.
D. The maximum sessions command must match the number of codecs configured under the dsp farm profile.
E. The sccp ccm group number must match the voice-card number.
Incorrect Answer: A, C, D, E The value of the IP address should match the IP address in the ip source-address command Link:
Q36. Refer to the exhibit.
How does the Cisco Unified Communications Manager advertise dn-block 2?
A. 14087071222 with number type international
B. +14087071222 with number type international
Q37. How many active gatekeepers can you define in a local zone?
Q38. Which three options are overlapping parameters for roaming when a device is configured for Device Mobility? (Choose three.)
C. network locale
F. device pool
Q39. Refer to the exhibit.
Which trunks would be most suitable for Connection Y?
A. an H.225 trunk (gatekeeper-controlled)
B. intercluster trunk (gatekeeper-controlled)
C. a SIP trunk on the U.S. cluster and an intercluster trunk on the remote cluster
D. intercluster trunk (nongatekeeper-controlled)
E. No extra connections are required. As long as IP connectivity exists, you need only configure a route pattern for each site. The Cisco Unified Communications Manager will automatically forward the calls over the WAN if the destination directory number is not registered locally.
Q40. Which three commands are mandatory to implement SRST for five Cisco IP Phones? (Choose three.)
E. ip source-address