The Only Tip You Need: 300 320 arch

We provide real 300 320 vce exam questions and answers braindumps in two formats. Download PDF & Practice Tests. Pass Cisco 300 320 arch Exam quickly & easily. The 300 320 arch pdf PDF type is available for reading and printing. You can print more and practice many times. With the help of our Cisco 300 320 dumps dumps pdf and vce product and material, you can easily pass the 300 320 vce exam.

The article at going over is very comprehensive.

Q141. A network engineer must provide 40mb connections from the data center to the corporate office and two remote offices. What WAN connectivity option will outsource the routing in cooperation with the service provider? 

A. Ethernet Private Line 

B. Ethernet Multipoint Service 




Q142. NBAR is deployed on the network as part of network optimization. Which technology is critical to recognize new applications on the network? 


B. ACLs 

C. code upgrade 

D. additional licenses 


Q143. What is the maximum number of neighbors that a router should have in an OSPF area? 

A. 5 

B. 30 

C. 60 

D. 99 


Q144. An organization is designing the IP allocation of a new site. It currently has 12 separate IP 

segments. Each segment must be /24, accommodate 25% of growth, and be easily summarized. 

Which summarized IP block can be subnetted to meet these requirements? 

A. /18 

B. /19 

C. /20 

D. /21 


Q145. Why is QoS important for in-band management? 

A. It supports remote management when traffic volume is high. 

B. It supports proper routing. 

C. It supports network security against DoS attacks and worm outbreaks. 

D. It supports network redundancy. 


Q146. Which two design recommendations are most appropriate when OSPF is the data center 

core routing protocol? (Choose two.) 

A. Never use passive interfaces. 

B. Use NSSA areas from the core down. 

C. Use totally stub areas to stop type 3 LSAs. 

D. Use the lowest Ethernet interface IP address as the router ID. 

E. Manipulate the reference bandwidth. 

Answer: B,E 

Q147. Addressing QoS design in the Enterprise Campus network for IP Telephony applications means what? 

A. It is critical to identify aggregation and rate transition points in the network, where preferred traffic and congestion QoS policies should be enforced 

B. Suspect traffic should be dropped closest to the source, to minimize wasting network resources 

C. An Edge traffic classification scheme should be mapped to the downstream queue configuration 

D. Applications and Traffic flows should be classified, marked and policed within the Enterprise Edge of the Enterprise Campus network 


Q148. Which of the following is most accurate with respect to designing high availability within the Enterprise Campus network? 

A. High availability at and between the Distribution and Access layers is as simple as redundant switches and redundant Layer 3 connections 

B. Non-deterministic traffic patterns require a highly available modular topology design 

C. Distribution layer high availability design includes redundant switches and Layer 3 equal-cost load sharing connections to the switched Access and routed Core layers, with a Layer 3 link between the Distribution switches to support summarization of routing information from the Distribution to the Core 

D. Default gateway redundancy allows for the failure of a redundant Distribution switch without affecting endpoint connectivity 


Q149. What is the correct state between two BGP peers that are neighbors? 

A. active 

B. operational 

C. established 

D. up 


Q150. An engineer is attempting to improve OSPF network performance and discovers that the entire SPT recomputes.whenever a type 1 or type 2 LSA is received within an area. 

Which action can optimize SPT operations? 

A. Tune LSA throttling thresholds. 

B. Enable incremental SPF. 

C. Configure totally stubby areas throughout the domain. 

D. Summarize networks on all ABRs.