All About 300-365 exam Mar 2017

Exam Code: 300-365 (Practice Exam Latest Test Questions VCE PDF)
Exam Name: Deploying Cisco Wireless Enterprise Networks
Certification Provider: Cisco
Free Today! Guaranteed Training- Pass 300-365 Exam.


The article at Testaimer.com going over http://www.testaimer.com/300-365-test is very comprehensive.

2017 Mar 300-365 vce

Q1. A network engineer is viewing the QBSS information in a packet sniff. Which two QBSS characteristics are crucial for successful troubleshooting? (Choose two.) 

A. When only WMM is enabled, information element number 1 QBSS Load information element is sent out in the beacons and probe responses. 

B. When only WMM is enabled, information element number 3 QBSS Load information element is sent out in the beacons and probe responses. 

C. When the client CAC limit is supported, information element number 2 is sent out in the beacons and probe responses on the bg radios. 

D. When the client CAC limit is supported, information element number 1 is sent out in the beacons and probe responses on the bg radios. 

E. When only WMM is enabled, information element number 2 QBSS Load information element is sent out in the beacons and probe responses. 

Answer: D,E 


Q2. A corporation has a Cisco Unified Wireless Network that has been deployed for voice coverage. The wireless data rates have been tuned to mandatory rates of 18 Mbps and 36 Mbps. Some wireless clients have been experiencing drops streaming multicast video while moving throughout the building. What is the cause of the drop in video? 

A. Clients are roaming at lower data rates and are not maintaining 36Mbps connectivity. 

B. Clients are not roaming due to coverage. This is causing the multicast data to drop due to the client re-associating often. 

C. Clients are connected at 18Mbps; however, other clients are connecting at 12Mbps and are causing the multicast video to degrade. 

D. Clients are maintaining a 12Mbps rate and cannot receive the stream at 18Mbps. 

Answer:


Q3. CORRECT TEXT 

Scenario 

One of your colleagues has setup a test network in the lab to simulate a new building atone of your regional offices. Your team is testing AP failover. Your colleague has requested you to configure the WLCs so that in the event of a loss of one of the WLCsthe other wings APs will fail over to the remaining WLC. 

The APs on the East-WLC-2504A should fail over to the West-WLC2-2504A, and the APs on the West-WLC2-2504A should fail over to the East-WLC-2504A. 

Set the priority of the APs so the backup controller recognizes the join request from the higher-priority AP and if necessary disassociates a lower-priority AP to provide access to an available port. 

Not all menus, tabs and features are supported. 

Topology 

Answer: 


Q4. After implementing mDNS gateway, a school's network administrator notices that mDNS wireless printers are available over the whole network. Which feature can the admin use to restrict the printer mDNS advertisements to the AP that the printer is joined to and adjacent APs? 

A. mDNS-AP 

B. SSO 

C. LSS 

D. Priority MAC 

Answer:


Q5. A customer has implemented a N+1 high availability plan in a multistory building. All APs on odd numbered floors are set as primary to WLC-A and all APs on even numbered floors are set as primary to WLC-8. Which two problems are likely to arise from this design? (Choose two) 

A. inconsistent CleanAir data due to multiple WLCs 

B. floor-to-floor bleed-through that causes intercontroller roaming delays 

C. AVC inconsistency due to multiple mobility group members 

D. legacy device compatibility with multiple WLC configuration that causes disconnects 

E. unpredictable AP loading during a WLC failure 

Answer: A,C 


Most up-to-date 300-365 simulations:

Q6. You have a VoWLAN configured for platinum QoS, WMM, and CAC. IP phones for this VoWLAN include the Nokia and Cisco Unified Wireless IP Phones 7920G (pre-v2.0 firmware), 7921G, and 7925G. The Wireless IP Phones 7921G and 7925G work properly, but the Nokia and the Wireless IP Phones 7920G associate with the WLAN but cannot place calls. What is the issue? 

A. The lowest mandatory speed in the WLAN is too high and needs to be reduced. 

B. The Cisco Unified Wireless IP Phones 7920G and Nokia IP phones do not support TSPEC. 

C. EDCA needs to be enabled on the WLAN. 

D. HCCA needs to be enabled on the WLAN. 

E. The reserved roaming bandwidth setting is set too low. 

F. The expedited bandwidth setting needs to be enabled. 

Answer:


Q7. What is the best practice for setting the WLC v7.0 use of WLAN QoS settings to support SIP phones on a VoWLAN? 

A. Configure SIP with static CAC only with SIP call snooping. 

B. Configure SIP with static CAC only without SIP call snooping. 

C. Configure SIP with load-based CAC only with SIP call snooping. 

D. Configure SIP with load-based CAC only without SIP call snooping. 

E. Configure SIP with load-based CAC and TSPEC only with SIP call snooping. 

Answer:


Q8. A network engineer observes a spike in controller CPU overhead and overall network utilization after enabling multicast on a controller with 500 APs. What feature is necessary to correct the issue? 

A. controller IGMP snooping 

B. unicast AP Multicast Mode 

C. broadcast forwarding 

D. multicast AP Multicast Mode 

Answer:


Q9. Which show command will show whether a WLAN is locally or centrally switched on a Cisco Wireless Lan Controller? 

A. show ap config general Cisco_AP 

B. show wlan wlan_id 

C. show flexconnect summary 

D. show flexconnect group detail 

Answer:


Q10. A network engineer is debugging issues with the mDNS gateway. Which type of reply should be seen in the Wireshark capture when querying for a mDNS service in the Bonjour Cache? 

A. unicast from Prime Infrastructure 

B. unicast from controller 

C. multicast from devices 

D. multicast from controller 

E. unicast from devices 

F. multicast from Prime Infrastructure 

Answer: