What Replace 352-001 Is?

352-001 could be the check-up computer code for Cisco quiz this also certification is just about the esteemed examinations in which honored on the source "Cisco". The following Cisco 352-001 certification can be said as the basic level certification together with sole quiz choice for achieving Cisco certification. Cisco 352-001 quiz could be the initial step for achieving the Cisco. It the particular applicants that will verify ale Cisco know-how. Cisco 352-001 is regarded as probably the greatest commencing qualified requirements you may go after. Hence, obtaining made a decision to study for Cisco you are on the correct program a prosperous qualified enhancement.

2021 Mar 352-001 exam fees

Q111. Which technique can you use to detect forwarding path failures at a uniform rate, and reconvergence times will be consistent and predictable when your routers are in the same broadcast domain? 

A. Enable BFD on your routers. 

B. Configure your routers with IP-SLA to ping the peer router. 

C. Configure your routers with IP-SLA and track to ping the peer and switch to a default route if the pings fail. 

D. Tune your routing protocol timers. 

Answer:


Q112. Your network operations team is deploying Access Control Lists (ACLs) across your Internet gateways. They wish to place an ACL inbound on the Internet gateway interface facing the core network (the "trusted" interface). Which one of these addresses would the ACL need for traffic sourced from the inside interface, to match the source address of the traffic? 

A. inside local 

B. outside local 

C. inside global 

D. outside global 

Answer:


Q113. A company plans to include Nonstop Forwarding and Bidirectional Forwarding Detection as a part of their network redundancy plan. In which two ways do NSF and BFD work together when different hardware platforms are compared? (Choose two.) 

A. During supervisor engine or routing engine failover, the NSF feature will always ensure that the BFD at the peer router will not trigger a link down independent of the used hardware platform. 

B. At some hardware platforms, BFD and NSF are not supported together. During supervisor engine or routing engine failover, the BFD at the peer router will trigger a link down. 

C. To ensure that BFD at the peer router will not trigger a link down during NSF, the BFD packets must be processed fast enough, and, during supervisor engine or routing engine failover, by processing the BFD independent from the supervisor engine or routing engine. 

D. Because BFD is always processed at the line cards (not at the supervisor engine or routing engine), a supervisor engine or routing engine failover will not affect the BFD peer router. 

E. Because BFD is always processed at the supervisor engine or routing engine, a supervisor engine or routing engine failover will always trigger a link down at the peer router. 

Answer: BC 


Q114. You are designing a network that will run EIGRP over a Metro Ethernet service that does not employ a link-loss technology. What will be the impact on convergence if there is a break in the end-to-end Layer 2 connectivity within the service provider network? 

A. The routers will immediately lose their adjacencies and converge. 

B. The routing protocol will not converge until the hold timers have expired. 

C. The switch ports connected to the router will go down and the routers will immediately converge. 

D. The VLAN on the switches will go inactive, the ports associated on the switch will go down, and the routers will immediately converge. 

Answer:


Q115. A company plans to establish a new network using Cisco Catalyst switches for its multicast applications. What is the disadvantage when two multicast applications are using the multicast IP addresses 234.17.4.5 and 234.145.4.5 inside the same network? 

A. Multicast packets from both applications are flooded to all Layer 2 ports in a segment where a multicast receiver is located. 

B. Multicast packets from both applications are flooded to ports where one multicast receiver from one application is located. 

C. Only one multicast stream is received at the port where the receivers from both applications are located. 

D. Both multicast senders will always receive the multicast packets from the other multicast application. 

E. The routers doing PIM-SM cannot distinguish between the two multicast applications. 

Answer:


Down to date 352-001 training:

Q116. What is a design aspect regarding multicast transport for MPLS Layer 3 VPNs using the Rosen Draft implementation? 

A. LDP is the multicast control plane protocol. 

B. Multicast traffic is forwarded over GRE tunnels. 

C. Multicast traffic is forwarded over LDP or RSVP signaled LSPs. 

D. Using the MDT SAFI in BGP ensures that PIM can be disabled in the core. 

Answer:


Q117. Refer to the exhibit. 

How would you adjust the design to improve convergence on the network? 

A. Add an intra-POP link between routers 1A and 1B, and enable IP LFA FRR. 

B. Use an IP SLA between the end stations to detect path failures. 

C. Enable SSO-NSF on routers 1A and 1B. 

D. Use BGP to connect the sites over the WAN. 

Answer:


Q118. A switched network is being designed to support a manufacturing factory. Due to cost constraints, fiber-based connectivity is not an option. Which design allows for a stable network when there is a risk of interference from the manufacturing hardware in use on the factory floor? 

A. Design the network to include UDLD to detect unidirectional links and take them out of service. 

B. Design the network to include EtherChannel bundles to prevent a single-link failure from taking down a switch interconnection point. 

C. Design the network to include loop guard to prevent a loop in the switched network when a link has too much interference. 

D. Design the network to include BackboneFast on all devices to accelerate failure convergence times. 

Answer:


Q119. As a service provider you must support a Layer 2 virtualization protocol that does not include the use of label switching. Which option can meet this design requirement? 

A. VPLS 

B. VRF-Lite 

C. QinQ 

D. 802.3ad 

Answer:


Q120. When network summaries are created for access networks in a network design, how does it change the behavior of the Shortest Path First (SPF) running in a backbone area? 

A. There would be fewer incremental SPFs. 

B. There would be fewer partial SPFs. 

C. There would be fewer full SPFs. 

D. There would be no change with the SPFs. 

Answer: