Jun 2017 updated: Examcollection Cisco 400-051 practice question 101-110

Our pass rate is high to 98.9% and the similarity percentage between our 400-051 study guide and real exam is 90% based on our seven-year educating experience. Do you want achievements in the Cisco 400-051 exam in just one try? I am currently studying for the Cisco 400-051 exam. Latest Cisco 400-051 Test exam practice questions and answers, Try Cisco 400-051 Brain Dumps First.


The article at Testaimer.com going over http://www.testaimer.com/400-051-test is very comprehensive.

Q101. Refer to the exhibit. 

You received this debug output to troubleshoot a Cisco IOS MGCP gateway problem at a customer site. What is the purpose of this message? 

A. The MGCP gateway uses this message to respond to an RQNT message from Cisco Unified Communications Manager. 

B. The MGCP gateway uses this message to respond to an AUCX message from Cisco Unified Communications Manager. 

C. The MGCP gateway uses this message to respond to an AUEP message from Cisco Unified Communications Manager. 

D. The MGCP gateway uses this message to respond to a DLCX message from Cisco Unified Communications Manager. 

E. The MGCP gateway uses this message to respond to an NTFY message from Cisco Unified Communications Manager. 

Answer:


Q102. Which statement describes the call recording operation on Cisco Unified Contact Center Express call agents that use Cisco IPPA? 

A. Recording is facilitated via desktop monitoring on supported IP phones. 

B. Automatic recording is supported. 

C. Only G.711 codec is supported. 

D. Only SPAN port monitoring is supported. 

E. Call recording is not supported on Cisco Unified CCX call agents that use Cisco IPPA. 

Answer:


Q103. Refer to the exhibit. 

Assume the B-ACD configuration on a Cisco Unified Communications Manager Express router is operational. 

How much time does a member of the hunt group have to answer a queue call that is ringing on their extension? 

A. 5 seconds 

B. 10 seconds 

C. 20 seconds 

D. 30 seconds 

E. 40 seconds 

Answer:


Q104. What is the maximum length of any numeric geographic area address in ITU recommendation E.164? 

A. 15 

B. 18 

C. 21 

D. 22 

E. 25 

Answer:


Q105. Refer to the exhibit. 

You received this debug output to troubleshoot a Cisco IOS MGCP gateway problem at a customer site. Which statement about this endpoint on the Cisco MGCP gateway is true? 

A. This endpoint is on a T1 Controller 0/1/0. 

B. This endpoint is on an E1 Controller 0/1/0. 

C. This endpoint is on a T1 Controller 0/1/1. 

D. This endpoint is on an E1 Controller 0/1/2. 

E. This endpoint is on an T1 Controller 0/1/2. 

Answer:


Q106. Refer to the exhibit. 

IP phone 1 has MAC address of 1111.1111.1111, and IP phone 2 has MAC address of 2222.2222.2222. The first two incoming calls were answered by IP phone 1, and the third incoming call was answered by IP phone 2. 

Which option describes what will happen to the fourth incoming call? 

A. Both phones ring, but only IP phone 2 can answer the call. 

B. Both phones ring and either phone can answer the call. 

C. Both phones ring, but only IP phone 1 can answer the call. 

D. Neither phone rings and the call is forwarded to 2100. 

E. Neither phone rings and the call is forwarded to 2200. 

Answer:


Q107. Refer to the exhibit. 

A user is going through a series of dialing steps on a SIP Type B IP phone (for example, a Cisco 7975) to call an SCCP IP phone. Both phones are registered to the same Cisco Unified Communications Manager cluster. Assuming that the calling SIP phone is not associated with any SIP dial rules, which statement about how digits are forwarded to Cisco Unified Communications Manager for further call processing is true? 

A. Each digit is sent to Cisco Unified Communications Manager in a SIP NOTIFY message KPML event, at the time that the user enters the digit on the keypad. 

B. The SIP IP phone will wait for the interdigit timer to expire, or for the Dial softkey to be selected before sending each digit to Cisco Unified Communications Manager as a separate KPML event in a SIP NOTIFY message. 

C. The SIP IP phone will wait for the interdigit timer to expire, or for the Dial softkey to be selected.before sending all digits to Cisco Unified Communications Manager in a SIP INVITE message. 

D. The SIP IP phone will wait for the interdigit timer to expire or for the Dial softkey to be selected before sending the first digit in a SIP INVITE and the subsequent digits in SIP INFORMATION messages. 

E. The SIP IP phone will send all digits to Cisco Unified Communications Manager in a SIP INVITE message as soon as the fourth digit is pressed. 

Answer:


Q108. Which configuration component in Cisco Unified Communications Manager Enhanced Location Call Admission Control is designated to participate directly in intercluster replication of location, links, and bandwidth allocation data? 

A. an active member of a Location Bandwidth Manager Group 

B. a member of a Location Bandwidth Manager Hub Group 

C. a standby member of a Location Bandwidth Manager Group 

D. all members of a Location Bandwidth Manager Group 

E. a shadow member of a Location Bandwidth Manager Hub Group 

Answer:


Q109. Refer to the exhibit. 

IP phone 1 has MAC address of 1111.1111.1111, and IP phone 2 has MAC address of 2222.2222.2222. The first two incoming calls rang both phones and were answered by IP phone 2. 

Which option describes what will happen to the third incoming call? 

A. Both phones ring, but only IP phone 1 can answer the call. 

B. Both phones ring and either phone can answer the call. 

C. Only IP phone 1 rings and can answer the call. 

D. Neither phone rings and the call is forwarded to 2100. 

E. Neither phone rings and the call is forwarded to 2200. 

Answer:


Q110. Which statement about Cisco EnergyWise domain member neighbor formation is true? 

A. Cisco EnergyWise supports static neighbors, but the neighbor relationship is only possible.if a noncontiguous domain member and a contiguous domain member have a static neighbor entry pointing to each other. 

B. Cisco EnergyWise static neighbors can be formed even if domain members are not physically contiguous. 

C. Static neighbors can be manually defined on Cisco EnergyWise domain members, but TCP protocols must be used. 

D. Static neighbors can be manually defined on Cisco EnergyWise domain members, but they have a lower priority compared to the autodiscovered members. 

E. Static neighbors can be manually defined on Cisco EnergyWise domain members and the TCP or UDP protocol can be used. 

Answer: